Schneiden

You can find the following functions in the Cut Object submenu of the Object menu or in the Editing and Drawing Toolbar.

Loch schneiden

This function is enabled when an area object is selected.
Choose this function to cut a hole out of an area. Any drawing mode can be used (Curve, ellipse, circle etc.). This is the procedure:

1. Select the object to cut a hole in.
2. Select a drawing mode (Curve, Ellipse, Circle etc.)
3. Choose the Cut Hole function.
4. Draw the hole.

Use Füllen oder Umranden to fill in the hole.
Change drawing mode with the Tab key before starting to cut.

a: Cut a hole in an area object, b: Fill in a hole
Cut a Hole

Fläche schneiden

This function is enabled when an area object is selected.
Choose this function to split an area into two objects.

You can use the Curve, Straight line, Rectangular line or Freehand mode to split an area object into two objects.

1. Select the area object to cut.
2. Select a drawing mode (Curve, Straight line, Rectangular or Freehand).
3. Choose the Cut Area function.
4. Draw the cut line. It must start at the border of the area, go across the area and end at the border of the area.

The area is now split into two objects. Note that the cut line should not cross a hole. Otherwise the hole may not be treated correctly for the 2 resulting objects.
After cutting the area object always the smaller of the two new area objects is selected.
Change drawing mode with the Tab key before starting to cut.

Linie schneiden

This function is enabled when a line or an area object with border line is selected.
Choose this function to divide a line into 2 objects or to cut a Virtual gap into a line object (introduced in OCAD 10), i.e. the line object is not divided, the gap concerns only graphic representation of the object.

Linienobjekt auftrennen

Click on the desired position anywhere on the line. The line is then split into 2 objects. One of them is selected.
You can use this function to influence the dashes of a dashed line.

Split a line object with cut-out

Instead of just splitting you can create a cut-out (a gap) in the line.

1. Choose the Cut function.
2. Place the mouse pointer at the start point of the cut.
3. Press and hold down the left mouse button.
4. Move the mouse pointer to the end of the cut.
5. Release the mouse button. The object is now divided into two and the cut-out portion is deleted.

-If you press the Ctrl key when cutting a line, the line is not divided into 2 objects. A Virtual gap concerning only the graphic representation of the object is inserted.

-If you press the Shift key when cutting a dashed line, you insert a gap with the same length, as the other gaps in the dashed line.

-It is possible to cut a part of the individual sidelines of double line symbols (like major roads), without having to cut the entire line itself.

Objekt schneiden

If you are looking for help on the Cut Object function, visit the Objekt schneiden page.

---

Back to the Edit Object page.