Difference between revisions of "Example Dashed Minor Road"

From OCAD Wiki - English
Jump to navigation Jump to search
Line 18: Line 18:
 
# Enter the width of the yellow infill in Width.
 
# Enter the width of the yellow infill in Width.
 
# Check '''Fill'''.
 
# Check '''Fill'''.
# Choose the white color in Fill color. Note that this color must be below the color of the dashed line in the color table, otherwise it will cover the dashed line. In addition, it must be above the color of the sidelines, otherwise crossings are not cleared automatically.
+
# Choose the white color in Fill color. Note that this color must be below the yellow and the black color. Otherwise it would not be visible..
  
 
[[File:OutDashed_DoubleLine.PNG]]
 
[[File:OutDashed_DoubleLine.PNG]]

Revision as of 10:52, 16 September 2013

MajorRoadMiddleLineFrameDashed.PNG

To create this symbol, start from an empty line symbol and then do the following steps:

In the Main Line page:

  1. Enter Line color and Line width.

OutDashed MainLine.PNG

In Distance page:

  1. Enter the dash length of the center line in Main length a.
  2. Enter the length of the gap in the center line in Main gap C.

OutDashed Distances.PNG

In Double line page:

  1. Choose Full lines for Mode.
  2. Enter the width of the yellow infill in Width.
  3. Check Fill.
  4. Choose the white color in Fill color. Note that this color must be below the yellow and the black color. Otherwise it would not be visible..

OutDashed DoubleLine.PNG

In Framing page:

  1. Enter Line color and Line width.

OutDashed Framing.PNG


Download link: [Example_DashedMinorRoad.ocd]


Back to Create a New Symbol